Our products

Heating Modules

  • heating modules 80kW and cooling 120kW
  • heat transfer fluid Seriola FG
  • 20m3/h heating rate
  • maintenance and cooling from 40 ° C to 250 ° C of reactors in pharmaceutical set-ups
  • stainless steel 1.4404 with local control box connected to power-control cabinet through Profibus network.

Central Heating

  • central heating 15kW and cooling 15kW
  • for 2m3/h of Therminol VPI oil
  • between + 40 ° C and + 385 ° C for high-temperature hydrogen storage
  • with three-way valve and flow meter for temperature control toward the receiver
  • drycooler
  • stainless steel with variable speed cabinet equipped with dual loop controller

Nitrogen Gas Heater

  • nitrogen gas heater up to 650 ° C
  • under 60 barg
  • Speed at 1000Nm3/h
  • 306kW
  • 7 heating rods with Boron Nitride
  • 321H stainless steel body for atomization of metal powders

Heater skids

  • steam superheating skid
  • steam superheating set saturated at 2.7 bar to 400 ° C
  • 115kg/h throughput on skid with 22kW electrical heater
  • pressure regulating valve
  • valve
  • trap
  • control and safety cabinet
  • continuous power dosage per thyristors block

Temperature Controllers

  • two temperature controllers with Rhodorsil Oil 47
  • flow rate 8m3 /h
  • + 190 ° c
  • 48 kW
  • bodywork
  • epoxy powder coating
  • with flow controller
  • expansion tank
  • double isolation valves
  • for impregnation vessel heating and cooking autoclave of graphite mines

Fuel Gas Heater

  • indirect to brine bath
  • ATEX zone
  • with level control
  • ATEX heater 40kW
  • stainless steel tank and coil
  • according to ASME Section VIII
  • Div .1. heating the gas above the dewpoint for gas turbine
  • Offshore Platform

Mobiltherm Oil Heater

  • Mobiltherm oil heater 603
  • 210° C
  • flow rate 16 m3/h
  • two pumps (one for emergencies)
  • gas boiler with double coil
  • insulation drain valves
  • blowhole
  • natural gas burner 300mbar
  • ramp with gas safety
  • control box with PLC managing burner and safety
  • drain tank with drain pump and separate expansion vessel

Oil Drycooler

  • power 120kW
  • for Marlotherm SH 280 ° C
  • flow rate 15 m3 /h
  • 2.5 barg pressure
  • two axial fans with variable speed to regulate power
  • steel finned tubes
  • manifolds and chassis coated with epoxy paint powder
  • baked
  • any outdoor condition

Natural Gas Heater 20kW

  • ATEX zone, 1000Nm3/h
  • 60 Barg
  • for heating gas before expansion
  • post on city gas distribution

Control Box

  • polyester control and regulation box IP65 for all outdoor condition
  • three-phase 20kW 400Volt
  • for natural gas heater

Thermal Oil Heater

  • Theminol thermal oil heater 66 to 300° C
  • flow rate 60m3/h
  • 6 barg
  • on stackable piece chassis
  • two 305kW electric heaters in series
  • with BJ temperature instrumentation and flow

Steam Generator

  • Steam production set saturated at 12 barA
  • 12 tonnes/h
  • from primary steam at 25 barA
  • with horizontal tank BEU beam
  • stainless steel tubes 20 ''
  • level control and safety devices for intermittent presence
  • condensate storage tank and preheat exchanger
  • safety valves
  • decentralisation and sludge flush valve
  • piloted water traps
  • control cabinet and safety management with PLC